TRENBuy me a coffee

Bends, releases and vibrato

Make notes sing: full and half bends that land right on the target pitch, controlled releases, and an even vibrato. A slow minor rock solo in box 1.

  • 56 → 72 → 84 BPM
  • 35 min
  • Acoustic and electric
Level 3 · Lesson 4Bends, releases and vibrato
Preparing the tab
Fretboard · notes sounding now
Measure 1 / 16

Measure 1 / 16

First the G string's 9: E, the target. Then put your ring finger on the G string at 7 with the middle and index behind it, and push the string up until you hear that E.

Reading the tab

7 with an arrow curving up and 'full' above it: a full bend, two frets up. The tie after it shows the bend is held.

Rhythm

Target on 1, rest on 2, bend on 3; it reaches pitch by the '&' of 3, then hold it through 4.

Click a measure to freeze it and look at each note · Shift + click: loop range · Space play/pause · ← → measure · L loop · M metronome · C count-in · + − tempo · Esc resume

All measure notes
  1. Measure 1 / 16

    First the G string's 9: E, the target. Then put your ring finger on the G string at 7 with the middle and index behind it, and push the string up until you hear that E.

    7 with an arrow curving up and 'full' above it: a full bend, two frets up. The tie after it shows the bend is held.

    Target on 1, rest on 2, bend on 3; it reaches pitch by the '&' of 3, then hold it through 4.

  2. Measure 2 / 16

    B string 10: A. Then fret the B string's 8 with your ring finger and push it up to A. Turn your wrist as if you were turning a door handle.

    8 full = the sound of the 10. After the bend, also try the high e's 5: it's A too, another check note.

    Same layout: target, rest, bend and hold. Sing the target in your head during the rest.

  3. Measure 3 / 16

    G string 6: C#. Then fret the G string's 5 with your index and pull the string down toward the floor for a half bend.

    The ½ mark: a half bend, one fret. It's a small move; pushing too far is the most common mistake.

    1 (2) 3 & 4: the bend is on 3, short and controlled.

  4. Measure 4 / 16

    Push the B string's 8 up to A, hold it, then let it down slowly to G. Your finger stays on the string.

    Up arrow, tie, down arrow: bend, hold, release. Tied notes aren't picked again.

    Bend on 1, release on 2, then E and D as quarters on 3 and 4.

  5. Measure 5 / 16

    D string 7: A. Shake the string with tiny bends up and down with your ring finger; the motion comes from the wrist.

    The wavy line (~) above the note means vibrato.

    1 & 2, 3-4: keep the vibrato even through the whole half note.

  6. Measure 6 / 16

    The chord is Dm. The last note is the G string's 7: D, the chord's root. Start the vibrato a moment after the note settles, not right away.

    A staircase down: C A G E, then D~.

    Four eighths, then a half note: 1 & 2 & 3-4.

  7. Measure 7 / 16

    Bend the G string's 7 up to E, hold it, and add vibrato while you hold: ease the bend a little and push it back, again and again.

    Bend arrow, tie and wavy line: vibrato on a bent note.

    1 &, bend on 2, hold through 3; beat 4 is a rest.

  8. Measure 8 / 16

    High e string 5: A, with index-finger vibrato. With the index too, the motion comes from the wrist.

    A half note with ~, then a half rest.

    Play on 1-2, rest on 3-4: get ready for the solo section.

  9. Measure 9 / 16

    The chord is F. Push the high e's 8 (C) up to D with your ring finger, hold, release; then the 5 and the B string's 8.

    The target would be the high e's 10. A bend on the thin string takes less strength but more control.

    1 bend, 2 release, 3 and 4 quarters.

  10. Measure 10 / 16

    The chord is G. A G E, then a full bend from the G string's 7 to E: the same bend as measure 1.

    The tie after the bend stretches the note to the end of the measure.

    1 & 2, bend on 3, hold through 4.

  11. Measure 11 / 16

    Bend and release in one note: G string 7, up to E and back to D. Then C, and A~ on the D string's 7.

    Up and down arrows on one note: bend-release. No second pick stroke.

    Up and down within the quarter on 1, C on 2, vibrato on 3-4.

  12. Measure 12 / 16

    Rest on 1, a half bend on the G string's 5 on 2 (C up to C#), then the D string's 7: A. A small touch of major color.

    ½: a one-fret bend. Like measure 3: index finger, string pulled toward the floor.

    (1) 2 & 3-4: the bend on 2, the A on 3.

  13. Measure 13 / 16

    The chord is Dm. Bend-hold-release on the B string's 8, then E, G and D: ending on Dm's root.

    Measure 4's bend with a new ending.

    1 bend, 2 release, 3 &, 4.

  14. Measure 14 / 16

    D C A G, then bend the G string's 7 up to E and add vibrato as you hold it. Don't let the top of the bend drift.

    D string 5 = G. Bend arrow, tie and ~ over the last beats.

    1 & 2 &, bend on 3, hold through 4.

  15. Measure 15 / 16

    Over F, a bend from the high e's 8 up to D, then A; over G, a bend from the B string's 8 up to A, then E. Two bends, two chords.

    Each bend is tied: hold it one more eighth, then move on to the next note.

    1 (&) 2, 3 (&) 4: the bends are on 1 and 3.

  16. Measure 16 / 16

    D string 7: A, with wide vibrato. Make the movement bigger but keep the speed steady.

    A thick wavy line: wide vibrato.

    A whole note: play on 1, vibrato for four beats.

Goal

#Your goal in this lesson
1Play full and half bends that land exactly on the target pitch, and check that pitch by ear.
2Release a held bend smoothly back to the fretted note.
3Play an even vibrato with the ring finger and with the index.
4Play the 16-measure solo four clean rounds in a row at 72 BPM.

Before you start

#Before you start, you should be able to
1You can play box 1 of the A minor pentatonic and a few licks from it (Minor pentatonic box 1).
2You know half and whole steps (one fret, two frets) and how ties work.
3Ideally you play an electric guitar with light strings (.009 or .010). Bends on an acoustic are possible, but much harder.

If any of these feel shaky, look up the matching concept in the Atlas.

Explanation

Listen to measure 1. First you hear an E played normally on the G string at the 9th fret. Then the D at the 7th fret slides up in pitch until it reaches that same E. That’s a bend: you push the string sideways across the fretboard, it gets tighter and the pitch rises. A guitar can’t play “between” frets any other way, which is why bends sound so vocal.

A bend has a target. In tab the arrow says how far:

Tab mark Name Rise Sounds like
full full bend a whole step the note two frets higher
½ half bend a half step the note one fret higher

How to check the target by ear. This is the most important habit in this lesson:

  1. Fret the target first. Play the note two frets higher (one fret for a half bend) on the same string and listen. Sing it or hum it if you can.
  2. Bend to match it. Play the bend and push until the pitch is the same. Too low sounds sour and “unfinished”, too high sounds strained; right on pitch, the two sounds merge.
  3. Use a second string. For a bend on the G string at 7 (D → E), the E is also at the B string’s 5th fret; for the B string at 8 (G → A), the A is at the high e’s 5th fret. Bend, then play that note right after it, or let both ring together: if they beat (“wah-wah-wah”), you’re not there yet.

The study is built that way: in measures 1-3 you hear the target note first, then the bend.

Technique. Bend with the ring finger, with the middle and index on the same string behind it, all three pushing together. The power comes from turning the wrist (like a door handle), not from the fingertip alone. Your thumb can hook over the top of the neck for leverage. On the G, B and high e strings you push the string up (toward the ceiling); the half bend on the G string at 5 with the index is pulled down instead.

Hold and release. In tab, a bend that keeps sounding is tied to the next note: you don’t pick again, you just keep the string where it is. A down arrow after it is a release: let the string back to its fretted pitch slowly and in time, without lifting the finger off the string. Measure 11 does it all in one note: up, down, no second pick stroke.

Vibrato is a row of tiny bends: the pitch moves up a little and back, over and over. It’s what gives a long note life. Keep the speed and width even; let it come from the wrist. With the index (measure 8) the motion is the same, only smaller. A held bend can get vibrato too (measures 7 and 14): ease the bend a little and push it back.

The study, over a slow Am rock groove:

PartWhat happens
A (measures 1-4)target, then bend: full bends on the G and B strings, a half bend, then bend, hold and release.
B (5-8)vibrato with the ring finger, vibrato on a held bend, vibrato with the index.
C (9-16)a solo that puts it all together, ending with a wide vibrato on A.

The strum lane is hidden in this lesson; read the rhythm from the beams under the tab.

Exercises

MetronomeRepeats / timePass criterion
1. Target practice

No metronome. On the G string: play 9, then bend 7 up to it. On the B string: play 10, then bend 8 up to it. On the high e: play 10, then bend 8. Check each bend with a second string as described above.

—10 bends per string.8 out of 10 bends land on pitch, neither under nor over.
2. Bend and release

Set the loop to measures 1-4.

56 → 72 BPM, in steps of 4.4 rounds at each tempo.Every bend reaches the target before the next eighth, and the release in measure 4 is smooth, with no extra note.
3. Vibrato

Set the loop to measures 5-8. Count your vibrato: aim for about two pulses per beat at 72 BPM.

56 → 72 BPM, in steps of 4.4 rounds at each tempo.The vibrato is even from the start to the end of each long note, and the bent note in measure 7 doesn’t sag.
4. Full solo and stretch goal

Play all 16 measures.

56 → 72 → 84 BPM.4 clean rounds in a row at 72 BPM; if you’re ready, 2 rounds at 84 BPM.Four clean rounds at 72 BPM. 84 BPM is a stretch goal.
5. Your own bend lick (creative)

Loop measures 9-12. Make a two-measure phrase with one bend and one vibrato, and end it on an A. Play it, then answer it with a second phrase that ends on a different note.

Common mistakes

SymptomCauseFix
The bend is flat (doesn’t reach the target)you push with the fingertip onlyput three fingers on the string and turn from the wrist; check the target note first every time.
The bend overshootsyou push “as far as you can”stop when the pitch matches the fretted target; half bends are only one fret.
Other strings ring while you bendthe bending fingers drag the neighborsmute the lower strings with the side of your picking hand and the higher ones with the tip of the index.
The release adds an extra noteyou pick again or lift the fingerkeep the finger pressed and only relax the push; the tie means no new pick stroke.
The vibrato sounds nervousit comes from the finger and changes speedslow it down, make it even and let the wrist do the work.
Your fingertip hurtsthe strings are heavy or the action is highthat’s normal at first; keep the sessions short and consider lighter strings.

Checklist

I can do itItem
My full and half bends land on the target pitch.
I can check a bend by ear with the fretted target or a second string.
I can hold a bend and release it smoothly without picking again.
My vibrato is even with both the ring finger and the index.
I can play the whole solo four clean rounds in a row at 72 BPM.

The lessons you mark and the concepts you see are stored only in this browser; no account. Your path