- Technique
- Level 3 · Groove and blues
- Main path
- You've seen this concept
Bend
Pushing the string to raise the pitch a half or whole step; it must land right on the target pitch.
Tab symbol b
From a short definition to sound, movement and timing.
Understand it on guitar
A bend raises the pitch of a fretted note by pushing or pulling the string sideways. Its quality is judged by the target pitch, not the size of the movement.
Concrete example
On the high E string, fret 7 is B and fret 9 is C#. A whole-step bend at fret 7 should sound like fret 9.
Practice in three steps
- Play fret 9 normally so you can hear the target note.
- Bend fret 7 until it matches that pitch.
- Release the bend smoothly, listening for the descent back to B.
Common mistake
Bending without a pitch reference often lands sharp or flat. Work slowly and avoid forcing the wrist.
Check it by ear
Play the target fret, then the bend. If you hear a difference in pitch, reduce speed and recalibrate.
Before this
Leads to
Lessons that use this
- Level 3 · Lesson 4Bends, releases and vibratoTeaches it Measure 1
- Level 3 · Lesson 15Level-end song: Rusty RailsAssumes it Measure 29
- Level 4 · Lesson 8Call and response improvisingAssumes it Measure 8 Measure 22
- Level 4 · Lesson 13Effects and tone designAssumes it Measure 17
- Level 4 · Lesson 15Level-end song: Velvet HourAssumes it Measure 39
- Level 5 · Lesson 2Wet PavementAssumes it Measure 1 Measure 15
- Level 5 · Lesson 3The FoundryAssumes it Measure 29
- Level 5 · Lesson 4Reading tabs from the internetAssumes it